Faria Instruments Antares IS0250a User Manual download pdf (Page 36)

Gauge Mount

Step 1: Cut a 3 3/8” round hole in your boat’s console

Step 2: Insert the Antares through the hole, placing the Gauge mount gasket (GK1234)

between the Antares unit and the panel.

Step 3: From back of panel, install back clamp. The two interior studs should line up

with the two holes of the back clamp. Tighten the supplied nuts, washers, and lock

washers to 7-10 inch pounds (slightly more than finger tight)

Step 4: Connect 9-pin (HN0604) and 20-pin (HN0605) wire harnesses to back of Antares

unit. Proper connection requires the locking ring on each harness to be rotated about ¼

turn.

Step 5: Connect available inputs to corresponding wire harnesses. See pages 34-37 for

detailed wiring information

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 42 43 44

No comments

Faria Instruments Antares IS0250a User Manual Page 36